Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.

This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

Support for oil temperature sensor

 This part is available by special order, request a quote

 03163330 GU03163330 03 16 33 30
 0316 3330 0316.3330 03.16.33.30

Sidestand cutout switch

See ELA81319 for rotary switch that was fitted to some models

 This part is available by special order, request a quote

 639542 MG639542

Chrome finish plastic horn cover

 Sorry, this part is no longer available.

 31744765 GU31744765 31 74 47 65
 3174 4765 3174.4765 31.74.47.65

Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with 12 volt 3 Ohm coils ELA14500 (big twins) and can be used to replace Digiplex on models with Ducati charging systems where the bike is converted to carburettors. This kit is just an ignition system, it will not control fuelling. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Once fitted no further adjustment should be necessary. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. See this link for fitting instructions. Some bikes may need at least one additional spacer to allow enough clearance for alternator cover to fit once pickup is fitted. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA14500

 This part is available by special order, request a quote

Round 12v two pin flasher relay for LED indicators. For use with aftermarket LED indicators

Includes rubber for attaching to bike.

NB Only suitable for LED indicators. Will not work in modern V7 models because these do not utilise a flasher unit.

 This part is available by special order, request a quote

Spark plug cap for longlife spark plug fitted behind cylinder

Also known as suppressor cap for 10mm spark plugs

 This part is available by special order, request a quote

 06717400 GU06717400 06 71 74 00
 0671 7400 0671.7400 06.71.74.00

Prolong battery life with this 9 stage smart battery charger, suitable for 6v, 12v AGM and lead acid batteries.

Weatherproof - suitable for use outside 6V / 12V 1A Auto-sensing charger. Suits all AGM, Lead Acid, Calcium and Gel batteries Charges 6v and 12v batteries Ring terminal and alligator clip harnesses included Spark proof Maintains full charge Simple, connect and wait for green light Overload / Short circuit protection See ACA96001 for a spare set of charging leads (e.g. for a separate bike).

 This part is due back in stock soon, call 01484 841395 to reserve yours

Pair of key blanks

Also known as Guzzi ref. 32735511 You will need to give these blanks to a locksmith together with your existing key to get copies made

 This part is available by special order, request a quote

 32735510 GU32735510 32 73 55 10
 3273 5510 3273.5510 32.73.55.10

Key blank for Zadi keys - check key profile before ordering

Key blank with plastic head for models without immobiliser chips

 This part is due back in stock soon, call 01484 841395 to reserve yours